The Hunter I-CORE irrigation controller is an expandable high-end controller packed with valuable contractor-friendly features at a very affordable price-poi
Open wire compartment cover by pushing straight down. Remove the phillips screw from the battery holder. Slide the battery holder down to access the battery. If the display goes blank after removing the battery, the transformer could be damaged and may need to be replaced. If the display continues with the "NO AC" message, then it needs a hard
SP ERR or ERR Message. CAUSE - Noise entering the controller through the “SmartPort” wiring or it is wired incorrectly. SOLUTION - A few steps are necessary to determine cause of “Err” message. 1. Check SmartPort ® Wiring. If the “Err” message is displayed without a device attached, check that SmartPort ® wiring is correct.
Advanced Features. The X2 controller lets you keep the familiar, dial-based programming style offered by the Hunter X-Core® controller. If you upgrade your X2 to Hydrawise control with the plug-in WAND module, programming is fast and easy thanks to a helpful setup wizard. Hydrawise maximizes water savings by automatically adjusting irrigation
a 24 VAC source from the controller. 6. Receiver Wires: The sensor wires are attached to either the sensor terminals in the controller or in-line with the valve common wire. • Blue/White Wires: Used for normally closed sensor applications (Hunter controllers). • Blue/Orange Wires: Used for normally open sensor applications. 7.
Bring two-wire technology to more projects than ever before with the revolutionary, low-cost, hassle-free EZ Decoder System for HCC, ICC2, HPC, and Pro-C controllers. Number of Stations 54 or 28. Type Modular Decoder. Platform HCC, ICC2, HPC, and Pro-C Controllers. HCC and ICC2 Controllers: Up to 54 stations, plus master valve.
zGPnBb. 335 290 421 20 106 453 89 410 312
hunter i core irrigation controller manual
